Millipore Simplicity system User Manual

Installation
11
Connection of the Power Cord − Turning on the System Power
A
• Open the front cover of the system (A).
This will allow the system to go into STANDBY mode once the
system is powered.
B
• Plug the Power Cord into the system (B).
• Plug the other end of the Power Cord into an appropriate source of
electrical power (i.e. wall outlet).
The system is immediately powered.
Start-up Displays
C
• Once the system is powered, the system will start to display
information about the software before going into STANDBY
mode (C).

Millipore Simplicity system Specifications

General

Brand	Millipore
Model	Simplicity system
Category	Water Filtration Systems
Language	English