Installation
16
Installation and Rinsing of the Final Filter
A
• Obtain a Final Filter. It can be the SimFilter™ Final Filter or the
BioPak® Ultrafiltration Cartridge.
• Remove the Tygon Tubing and the Barbed Fitting from the POU
Dispenser.
• Screw the Final Filter onto the end of the POU Dispenser.
The Final Filter should be turned until it is hand tight (A).
Do not over tighten the Final Filter.
ATTENTION
Do not use white tape on the threads of the Final Filter. The POU Dispenser has
an O-ring inside which provides a watertight seal.
B
• Press the Main Button to put the system into DISPENSING mode (B).
• For the SimFilter Final Filter, dispense about 0.5 Litre of water. For
the BioPak Cartridge, refer to the instructions shipped with the filter.
• Press the Main Button. The system will finish dispensing water.
• Leave the system in PRE OPERATE mode.
ATTENTION
It is highly recommended not to put Tygon Tubing or any other type of tubing
on the end of the Final Filter. This can compromise the Product Water quality
(bacteria can grow in the Tygon Tubing).
• The Water System is now ready for use.
To Next Page
Loading...
Need help?
General
