MAINTAINING OPERATION
With programming complete, record all parameter alterations.
a) If the keypad programmer is used, enter the program mode and scroll
access altered parameters (skipping parameters left at preset values).
Record parameter alterations on the PROGRAMMING CHARTS.
b) If the DOLPHIN interface package is used, refer to the associated
instructions to record all operator programming.
For normal operation, return to the RUN mode. The HYDRO+ will perform reliably,
requiring little or no maintenance.
Connect (or enable) process control/alarm equipment to the
HYDRO+ only after satisfactory performance is verified for
all possible operating conditions.
PROGRAMMING CHARTS
PL-507 38
To Next Page
Loading...
