SPECIAL PARAMETERS
Some Parameter Values are for display purposes only and cannot be operator
altered. These are referred to as
view only
parameters.
In the PARAMETERS section of this instruction manual, View Only parameters are
identified by a "(V)" beside the Parameter Number.
Many Parameter Values must be common for all Point Numbers. These are referred
to as
global
parameters.
When a global parameter is accessed, the Point Number display automatically
disappears. When a non-global parameter is accessed, the Point Number previously
selected is displayed.
In the parameters sections of this manual, Global parameters are identified by a "(G)"
beside the Parameter Number.
PARAMETER RESET FEATURES
To return an operator adjusted Parameter Value to the preset value, with the
appropriate Parameter Number (and Point Number if applicable) displayed...
To reset all parameters to preset values, see Master Reset (P999).
Perform a Master Reset (P999) to preset all parameters to "original"
values before initial system installation, following an EPROM
replacement, or whenever complete reprogramming is required.
PARAMETERS
PARAMETERS
PROGRAMMING
PL-507 31
To Next Page
Loading...
