3-56
Select the number of pinch roller to use
Set the number f pinch roller to detect when the sheet detection.
For the machine with more than three pinch rollers, it is displayed.
1
Press the key in the local mode.
2
Press the jog key or to select [SET UP] .
3
Press the key.
4
Press the jog key or to select [PINCH
ROLL] .
•
5
Press the key.
6
Press the jog key or to select the number
of pinch roller to detect.
• PINCH ROLL: 2 or 3
7
Press the key.
8
Press the jog key or to select the setting of
“ROLL. SELECT”.
• When selecting the number of pinch roller at sheet detection, select
“ON”.
9
Press the key twice for terminating this function.
• If “2” is set to “PINCH ROLL” and “OFF” is set to “ROLL. SELECT”, only 2 pinch rollers will be
detected at sheet detection.
• When using wider sheet, you may wish to limit the number of pinch roller because you do not want to
leave the trace of the roller on the sheet. In such a case, as there is the possibility that the sheet
driving accuracy will become lower, make the cutting speed and up speed low enough or set “HEAVY”
to [SHEET TYPE] to limit the driving speed. By doing this, you can gain better cutting result.
FUNCTION
To Next Page
Loading...
