1-11
1
Before Use
3
4
5
6
Menu mode
This plotter is provided with the following four modes:
< NOT-READY > mode
The plotter is in this mode until the media is detected.
The keys other than the key are effective.
< LOCAL > mode
The plotter enters this mode after the sheet detection.
All the keys are effective.
The plotter can receive data from the computer. However, data processing of cutting (plotting) and similar data
is not performed.
(Doing so could result in a processing error depending on the application software.)
< REMOTE > mode
The plotter performs cutting (plotting) according to the received data.
Pressing the key interrupts the cutting operation and returns the plotter
to the LOCAL
mode.
Pressing the key once again resumes cutting.
Pressing the key during cutting brings the plotter into the HOLD
state.( P.3-48)
< FUNCTION > mode
To set the FUNCTION mode, press the key when the plotter is in the LOCAL mode.
Set various cutting (plotting) conditions in this mode.
If there is data for which cutting has not been finished yet, there is a case where you cannot change settings.
In such a case, let the cutting finish or execute [DATA CREAR] first and then start changing the settings.
( P.3-48)
REMOTE
This indicates the amount of
data received. Once cutting
(plotting) is started, the
amount of data will decrease
in steps of 1 KB.
To Next Page
Loading...
