3-54
Make the media without uncut area
By over lapping the start point and the end point arbitrarily, you can make the media without uncut area.
Specify the over cut function (valid/invalid) and the length of the over
cut. If the length of the over cut is set, when cut starts, cut will be
performed from the position to the front by the specified length and the
tool will move up going too far at the end.
Additionally, you can enable the corner cut function to perform over-
cutting of corners other than the start and end points.
1
Press the key in the local mode.
2
Press the jog key or to select [SET UP] .
3
Press the key.
4
Press the jog key or to select [OVER CUT].
5
Press the key.
6
Press the jog key or to select OVER CUT
setting.
• Setting value: OFF or a value from 0.1 to 1.0mm (0.1mm unit)
7
Press the key.
• Setting proper over cut can reduce uncut area of start and end
point of a media easy to bend. If too large value is set, the
result may have a rupture
To Next Page
Loading...
