3-43
1
1
3
Useful Function
5
6
Perform DIVISION cut
Cut Data via DIVISION CUT.
1
Send data from the host computer to the plotter.
• If the data exceeds the available cutting area, the display
shown at right will appear.
2
When cutting completes, the plotter automatically cuts
the frame and area marked for gluing.
• On the display panel, the time for completing cutting of the frame
and area marked for gluing appears.
3
Upon completion of the frame cutting, the plotter will
return to local mode.
• Do not replace the sheet when any other display is shown.
4
Set the new origin.
• Move the carriage using jog keys (arrow keys) to establish the origin.
• If the sheet has no space for cutting, replace the sheet with a new one.
5
Press the key to set the plotter in remote
mode.
• Feed the sheet by the maximum sheet length necessary for the cutting data and start cutting.
• If the sheet is not fed or the sheet is not sufficiently long, replace the sheet with a larger one in step 4
above.
6
Repeat steps 4 and 5.
• Repeat those steps until there is no data that exceeds the sheet width.
• Upon completion of cutting for all the data, the plotter will return to local
mode, displaying the tool conditions
• For division cut in the X direction (feeding direction), when cutting (drawing) of the set
area has been completed, the machine performs feeding and if it is not sheet end,
copying/ cutting (drawing) automatically starts.
• If it is sheet end, division cut in the X direction (feeding direction) is terminated.
To Next Page
Loading...
