2-13
1
2
Basic Operations
4
5
6
Setting a sheet
Either a leaf sheet (cut sheet) or a roll sheet can be loaded on the plotter.
The pinch rollers and grit rollers hold the sheet in position.
Locate the pinch rollers so that they match the sheet to be used.
Sheet width
• CG-100SRIII/ CG-130SRIII have three pinch rollers (CG-60SRIII has two). When setting a slippery
surface material, such as a soft sheet, wider sheet, or film, set a pinch rollerto the both sheet ends
and the center. For a narrow sheet, no need to set the pinch roller in the center of the sheet.
• When in use of the center pinch roller, it may have the mark of the grit roller in the sheet.
mm inch
CG-60SRIII 90 to 740 3.55 to 29.10
CG-100SRIII 90 to 1250 3.55 to 49.20
CG-130SRIII 90 to 1550 3.55 to 61.00
To Next Page
Loading...
