3-3
1
1
3
Useful Function
5
6
Functions in the Jog Mode
Two-point axis alignment
If a ruled sheet is set, align the horizontal and vertical axes with the
appropriate lines on the sheet.
Correct the axial inclination (θ) by setting a compensation point in
combination with the origin.
1
Press the key to set to the local mode.
• Confirm in advance that even if you press the key to enter
the remote mode, the plotter does not perform cutting (plotting).
2
Set the Origin by pressing the jog key , ,
or to and press the key.
3
Press the jog key , , or to enter
the jog mode.
• Press either one of the jog keys, and you can enter the jog mode.
4
Press the
key.
5
Press the jog key , , or to set
the compensation point.
• θ= -45 to 45 degrees
6
Press the
key to decide the origin.
• The display is as shown on the right briefly, after which the plotter
returns to the local mode.
• When you clear the compensation point, move the clamp lever to the rear side to make the clamp
OFF and perform sheet detection (
P. 2- 1 4) again.
To Next Page
Loading...
