MIMAKI CG-130SRIII - Alignment of Mark Sensor

3-33
1
1
3
Useful Function
5
6
Cut Out Data with Registration Mark
Alignment of MARK SENSOR
The offset value of the cutter and the mark sensor can be adjusted.
Set the sheet on which the register mark is printed.
1
Install a cutter in the tool holder.
2
Confirm that the plotter is in the local mode.
3
Press the key.
4
Select [MARK SENSOR] by pressing the jog key
or .
5
Press the key.
6
Select [SENSOR OFS] by pressing the jog key or
.
7
Press the key.
• The offset value of the cutter and the mark sensor can be adjusted.
• Set the sheet on which the register mark is printed.
FUNCTION
ENTER/HOLD
ENTER/HOLD
A direction
B direction
Misaligned by +0.2 mm
from the center line of the
register mark ( ) in
the A and the B direction.