3-2
Functions in the Jog Mode
Press the jog key , , or in the local mode, and then you can enter the jog mode, where
you can perform the following settings.
Setting the origin
1
Press the key to set to the local mode.
• Confirm in advance that if you press the key to enter the
remote mode, the plotter does not perform cutting (plotting).
2
Press the jog key , , or to enter
the jog mode.
• Press either one of the jog keys, and you can enter the jog mode.
3
Press the jog key , , or to set
the origin.
4
Press the
key to decide the origin.
• After displaying the effective cutting for while, the plotter returns to
the local mode.
Function names Contents
Reference
page
Setting the origin Set the point from which the plotter will start cutting (plotting). P.3-2
Two-point axis alignment
If a ruled sheet is set, align the horizontal and vertical axes with the
appropriate lines on the sheet.
P. 3- 3
Cutting area Set the area in which the plotter performs cutting (plotting). P.3-4
Up and Down
of the Pen
This is to put up and down the tool.
(Press the key in the jog mode).
-
• Before you set the function in the jog mode, be sure to confirm that there is no cutting (plotting) data.
• When the origin or any other point is set in the jog mode, the center of the tool corresponds to the
setting point regardless of the light pointer on/off.
• The sheet could fall out if the sheet sensor is disabled, and the leading edge of the sheet is not
detected with the head on top of the sheet sensor.
TOOL
REMOTE
To Next Page
Loading...
