Other Useful Functions
1
1
3
Useful Function
5
6
3-59
Setting the PRE FEED
Perform next setting about automatic paper feeding after sheet detection.
1
Press the key in LOCAL mode.
2
Press the jog key or to select [SET UP].
3
Press the key.
4
Press the jog key or to select [FEED
OPTION] .
5
Press the key.
6
Press the jog key or to select [PRE FEED].
7
Press the key.
• The feed count setting is displayed.
Set Item
Set Value
*1
*1. The setting at the time of purchase is indicated with the underline.
Overview
Feed count 0, 1, 2, 3, 4, 5
Sets the number of feedings of the sheet back and forth.
By feeding the sheet, cutting (plotting) quality can be improved.
Feed length 0.1 to 0.3 to 5m
Sets the feed length of the sheet.
By feeding the sheet by the amount to be cut (plotted) in advance, as the
sheet can adjust itself to the work environment, cutting (plotting) quality can
be improved.
Wait time 0 to 1 to 90 sec
Sets the time until cutting (plotting) starts after the sheet is fed.
Over feed ON/OFF
When you cut (plot) two and more pages, by feeding second sheet in
advance, the cutting (plotting) efficiency can be improved when the waiting
time is set.
To Next Page
Loading...
