4-2
Before taking a phenomenon as a trouble
Take appropriate remedies according to the table below.
If still the problem cannot be solved, contact MIMAKI or its dealer.
Phenomenon Cause Remedy
Power does not turn on.
The power cable is not connected
properly.
Connect the power cable to the
plotter and to the wall outlet properly.
The plotter cannot perform cutting
(plotting).
The plotter name setting on the host
computer is wrong.
Check the plotter name setting on
the host computer.
The interface cable is not securely
connected to the plotter and the host
computer.
Securely connect the interface cable.
USB driver has not been installed.
Install USB driver supplied with Fine
Cut.
An error arises in the plotter when
the host computer sends data to
the plotter.
Command settings are wrong.
Correct the command settings
between the application software and
the plotter.
Plotter model setting is wrong.
Correct the plotter model setting to
[CG-SRIII series] on the application
software.
The plotter cannot detect the
sheet.
A transparent sheet or a sheet
whose back side is black is used.
Set the sheet sensor function to OFF.
(
P. 3 - 77 )
By cutting operation, the sheet is
not cut, but perforated.
Screw for the tool holder is loose. Tighten up the screw.
The cutter blade protrudes
excessively.
Adjust the protrusion of the blade
properly.
Half cut is set to “ON”.
Make “OFF” of half cut of the tool
condition.
The blade is chipped or worn out. Replace the blade with a new one.
The blade does not rotate
smoothly.
Replace the holder with a new
one.
The actual cut length is different
from the length specified on the
data.
The sheet feeding length varies
with the sheet thickness.
Correct the error margins by
executing the distance compensation
function.
(
P. 3 - 6 )
Slippage of sheet arises in cutting.
The pinch rollers and grit rollers fail
to securely retain the sheet in
position.
Check the position of the pinch
rollers and grit roller and adjust them
so that they securely retain the sheet
in position.
The clamp pressure (high or low
mode) has not been properly
selected.
Select the proper clamp pressure.
(
P. 1 - 8 )
There is a slack in the roll sheet so
that the sheet being fed meanders
or skews.
Remove the slack in the roll sheet
and straighten the right and left end
faces of the roll when loading the roll
sheet on the plotter. Then, start
feeding the sheet.
To Next Page
Loading...
