Cutter blade
5-5
1
1
1
1
5
Appendix
Replacing the cutter other than supplied one
1
Loosen the lock nut, and pull the adjusting knob
out of the holder.
2
Insert the cutter into the adjusting knob using
tweezers.
3
Tighten the lock nut.
Adjusting blade edge of cutter other than supplied one
After the completion of adjustment, be sure to set cutting conditions and perform test cutting to check the
cutting quality.
1
Remove the cutter holder, and loosen the lock nut.
」
2
Turn the adjusting knob to adjust the protruding
amount of the cutter blade.
3
Tighten the lock nut so that the adjusting knob will
not turn.
• The blade adjuster (adjuster: OPT-S1005) will facilitate the adjustment of the protruding amount of the
blade.
To Next Page
Loading...
