2-23
1
2
Basic Operations
4
5
6
Cutting (plotting)
You can start cutting (plotting) after completion of setting up a tool, a sheet and the tool conditions.
Setting the origin
The origin is a reference point for the cutting (plotting) data.
When the origin is changed, set the new origin before starting cutting (plotting).
1
Move the carriage to a point at which the new origin
is to be set.
• : Moves the carriage to the right.
: Moves the carriage to the left.
: Feeds the sheet to the rear of the plotter.
: Feeds the sheet to the front of the plotter.
• Every time you press the key, the tool will move up
and down alternately.This helps you to set the origin at a correct position.
2
Press the key to register the origin.
• The display panel will show the effective cutting area first and then
the tool conditions.
• Check the following settings before cutting (plotting).
Setting of the origin ( P.2-23)
Setting of the command origin ( P.3-77)
Switching between commands ( P.3-77)
Priority of commands ( P.3-77)
Setting of the maximum size response value ( P.3-77)
• Change the origin before cutting the next data; otherwise, cutting will be performed over the previous
data.
To Next Page
Loading...
