3-32
3
Confirm that the plotter is in the local mode.
4
Press the key.
5
Select [MARK SENSOR] by pressing the jog key
or .
6
Press the key.
7
Select [POINTER OFS] by pressing the jog key
or .
8
Press the key.
• A 10 mm by 10 mm cross pattern will be cutted.
• The light pointer turns on and moves to the center of the cross pattern.
9
By pressing the jog keys and , adjust the light pointer
position so that the center of the light pointer is in alignment with the center of the
cross pattern.
10
Press the key.
• The plotter will return to the local mode after registering the
compensation value.
• The value registered in the [POINTER OFS] is not initialized even by executing the [SETUP RESET].
FUNCTION
To Next Page
Loading...
