MIMAKI CG-130SRIII - Page 26

2-2
Operation flow
1
Installing a tool
2
Turning the power on
3
Setting the tool conditions
4
Setting a sheet
5
Test cutting (plotting)
6
Cutting (plotting)
See “Installing a tool” ( P.2-3)
See “Turning the power on”
(P.2-8)
See “Setting the tool conditions”
(P.2-9)
See “Setting a sheet”
(P.2-13)
See “Test cutting (plotting)”
(P.2-22)
See “Cutting (plotting)” ( P.2-23)
7
Turning the power off
See “Turning the power off”
(P.2-26)