2-21
1
2
Basic Operations
4
5
6
Setting a sheet
8
Press the jog key or to select [ROLL].
• For “Sheet detection” ( P.2-14)
• : In the case the sheet is loaded from the rear
• : In the case the sheet is loaded from the front
9
Press the jog key or to select number of
pinch rollers to be used. (CG-130SRIII)
• When [ROLL. SELECT] is set to [ON], select the number of pinch
rollers to be used.
( P.2-14)
10
Press the key.
11
Perform [FEED] and pull out the sheet of the length you use. ( P.3-47)
• When you press the key, the screen to select the number of pinch rollers is
displayed before sheet detection. After selecting the pinch roller, sheet detection is
performed.
• The number of pinch rollers set here has priority over the one selected from [SET UP] -
PINCH ROLL.] menu.
• Before you use the roll sheet, previously pull out the sheet of the length you use to make enough
room. By feeding out the sheet, you can verify if there is any sheet misalignment or not.
To Next Page
Loading...
