3-36
Expand the cutting (plotting) area
7
Press the key.
8
Press the key twice for terminating this function.
Set EXPANDS function to “OFF”.
• When the Expand mode is set to ON, paper jam can occur if excessive pressure is applied to the
sheet.
• If axis compensation is not performed, the cutter blade can run out of the sheet and may cause a
paper jam. A cutter blade having run out of the sheet may damage itself or the plotter.
• The cutting quality of the areas that come in contact with the pinch rollers will be lowered.
• If a pinch roller comes in contact with a registration mark during its detection, the registration mark
may not be detected properly.
• Once the Expand function is set after sheet detection, be sure to perform sheet detection again.
Follow the Steps 1 to 5 of
“Set the EXPANDS
function to ON.”
Press the jog key
to select
“OFF.”
Press the
key.
Press the
key twice.
To Next Page
Loading...
