MIMAKI CG-130SRIII - Page 88

3-38
Switch the cutting (plotting) direction
Coordinate system
The plotter has four different coordinate systems established by combinations of the sheet setting direction and
the rotation of the coordinate axes.
Reset the Setting of ROTATION.
Follow the Steps 1 to 5 of
“The Setting of
ROTATION.”
Press the jog key
to select
“OFF.”
Press the
key.
Press the
key twice.
< 0° ROTATION >
The sheet is loaded
in the rear of the
plotter.
< 90° ROTATION >
The sheet is loaded in
the rear of the plotter.
Rotation: OFF Rotation: ON
Rotation: OFF Rotation: ON
The sheet is loaded
in the rear of the
plotter.
The sheet is loaded in
the rear of the plotter.
< 180° ROTATION > < 270° ROTATION >
ENTER/HOLD
END