3-40
6
Press the jog key or to select “Y”
7
Press the key.
8
Press the jog key or to select [FRAME
CUT] .
• Select “ON” for the frame cut.
9
Press the key.
10
Press the jog key or to select [MARK CUT].
• Select “ON” for the mark cut.
11
Press the key to perform setting, and press the key twice to
terminate this function.
• The setting values are kept in memory even when the power is turned off.
• Since the overlap margin is 1 cm, the available cutting area must be wider than 1 cm.
• During execution of division cutting, the plotter ignores any other data sent from the host computer.
• In any of the following cases, the plotter cannot perform division cutting.
The data size is larger than the receiver buffer capacity.
An origin renewal command is contained in the cutting data.
A two-point compensation value has been set.
The registration mark detection is being performed.
The width of available cutting area is 1 cm or less.
The plotter cuts the test data stored in it.
• When you use FineCut, the default value of Origin Renewal is “ON”. If you perform [DIVISIONcut],
uncheck the checkbox. (Refer to FineCut OPERATION MANUAL Chapter5 “Setting Head Position
after Plotting”)
To Next Page
Loading...
