ix
WARNING
Do not disassemble or remodel the plotter. Handling of the power cable
• Never disassemble or remodel the plotter.
Disassembly or remodeling can result in an
electric shock or breakdown of the
machine. Do not use the plotter in a damp
place.
• Use the supplied power cable. Take care
not to damage, break or work upon the
power cable. If a heavy material is placed
on the power cable, or if it is heated or
pulled, the power cable can break, thus
resulting in fire or electric shocks.
Avoid locating the plotter in a damp
environment.
• Do not splash water onto the machine. Use
in such an environment can give rise to fire,
electric shocks or breakdown of the plotter.
In case abnormal event occurs.
• Use of the plotter under an abnormal
condition where the device produces
smoke or strange smell can result in fire or
electric shocks. If such an abnormality is
found, be sure to turn off the power switch
immediately and unplug the cable from the
wall outlet. Check first that the plotter no
longer produces smoke, and contact your
distributor for repair. Never repair your
plotter by yourself since it is very
dangerous for you to do so.
CAUTION
A place exposed to direct
sunlight
On an inclined surface A place where temperature or
humidity varies significantly
• Use the plotter under
the following
environmental
conditions:
Operating environment:
20 to 35°C
35 to 65% (Rh)
A place that vibrates A place exposed to direct air
flow from an air conditioner or
the like.
Around a place where flame is
used
To Next Page
Loading...
