5-2
Specifications of the main unit
Item CG-60SL
Acceptable roll sheet width
mm inch
90 ～ 740 24 ～ 40
Acceptable leaf sheet width
90 ～ 740
Acceptable roll sheetweight Sheet weight : 8 kg or less
Effective cutting area
*1
*1: The maximum feed length is limited by the software.
The maximum feed length is limited also by the sheet setting condition or by the effect of obstacles
encountered on the sheet path. As a rule of thumb, limit the maximum feed length for one of the data to 2 m.
586 mm X 51 m
Maximum speed
*2
*2: The maximum speed may be limited by the sheet size.
The plotter cannot perform cutting (plotting) at the specified maximum speed or maximum acceleration.
Apporox70 cm/s (in the 45-degree direction with the pen up.)
Speed setting
(cutting/plotting)
1 ～ 10m/s (in 1 cm/s steps), 10 ～ 50cm/s (in 5 cm/s steps)
Mechanical resolution
5μm
Program steps
25, 10μｍ (MGL-IIc) , 100, 50, 25μm( MGL-Ic1)
Repeatability
*3
*3: To achieve the guaranteed range of accuracy, the next page's requirements must be satisfied.
± 0.2 mm (excluding expansion/contraction due to film temperatures)
Guaranteed range of
accuracy (repeatability)
586 mm X 2 m (depending on the specified film and cutting conditions)
Maximum pressure 400 g
Pressure
setting
Cutter
10 ～ 20g(2 g step) , 20 ～ 100g(5 g step) , 100 ～ 400g(10 g step)
Pen
10 ～ 20g(2 g step) , 20 ～ 100g(5 g step) , 100 ～ 150g(10 g step)
Acceptable films
PVC sheets (0.25 mm thick or less),
fluorescent sheets
*4
, reflective sheets
*4
*4: The blade (SPB-0007) dedicated for fluorescent sheets or the blade (SPB-0006) dedicated for reflective
sheets must be used.
Acceptable sheet for
pouncing
Paper (thickness: 0.06 to 0.13 mm)
*5
*5: The dedicated pouncing tool must be used.
Applicable tools
Eccentric cutters,water-based ball-point pens, oil-based ball-point
pens, commercially available ball-point pens
*6
*6: Use the tools supplied as standard accessories.
If any other ball-point pen available on the market is to be used, select the one whose diameter is 8 to 9 mm
and which is free from bumps or taper in the area to be clamped. The image quality is not guaranteed
because the pen tip position differs depending on the pen in use.
Commands
*7
*7: With the USB connection, the ESC type commands among the MGL-llc commands cannot be used.
MGL-IIc、MGL-Ic1
Interface USB
Receiver buffer 30 MB standard (20MB when the sorting function is effective.)
Operating environment
5 to 35°C, 35 to 75 % (Rh) Non-condensing
Power capacity
AC100 to AC240 V ± 10%, 50 / 60 Hz, 145 VA or less
Outside
dimensions
(W) 960 mm
(D) 430 mm
(H) 335 mm
Weight 18 kg
Noise
*8
*8: The values are based on MIMAKI's measurement conditions.
During standby (plotting) 55 dB (Absorption fan at low speed)
During cutting (plotting) 70 dB (Continuous sounds)
To Next Page
Loading...
