3-23
3
Useful Function
Other Useful Functions
Feed the paper
Before starting cutting (plotting), feed the sheet manually by the
length to be used.
In addition, by feeding the sheet beforehand, you can check for a
skew of the sheet or prevent skew
while cutting (plotting) the long data.
1
Press the key in the local mode.
2
Input the feed amount using the jog key
or .
• Setting value
In “mm” : 0.1 m to 51.0 m (in increments of 0.1 m)
In “inch” : 1 to 167 feet (in increments of 1 ft.)
3
Press the key.
• The sheet will be fed by the input length.
• If you start the plotter for high-speed cutting without
feeding the leading edge of the roll sheet by some
length beforehand, there may be a case where the
feeding the sheet is not started and thus the plotter
goes into an error state.
• The key does not work until the sheet is
detected.
• To interrupt the sheet feeding, press the key.
• If the sheet length is shorter than the set value, sheet feeding
stops, displaying the fed sheet length.In this case, press any
key to clear the display.
FEED
CUT1 2 0 050 0 . 3 0
SHEET FEED: 1 . 0m
FEED
SHEET FEED: 10 . 0m
SHEET FEED: 8 . 0m
ENTER/HOLD
END
** STOP:0.2m **
To Next Page
Loading...
