MIMAKI CG-60SL - Perform Multiple Cuttings

3-10
Perform Multiple Cuttings
This function performs cutting (plotting) for the received data on two or more sheets.(Maximum 999
cuttings)
• You can perform multiple cuttings by specifying data saved in the receiving buffer of this device.
• The receiving buffer can save only one data.
• When a new data is received, the data that has been saved is overwritten by it.
(You cannot perform multiple cuttings by specifying the data that was received before.)
1
Press the key in the local
mode.
2
Press the jog key or to select
[No. COPIES] .
3
Press the key.
4
Press the jog key or to select
the number of cutting (1 to 999) ,and
press the key .
5
Press the jog key or to select
the interval of figures to be cut (0 to
30mm) ,and press the key .
Copy interval
The origin at executing the
multiple sheet cutting.
(Manual setting)
The origin at terminating
the multiple sheet cutting
(Automatically established)
DATA CLEAR <ENT>
FUNCTION
No .COP I ES <ENT>
No .COP I ES : 1
ENTER/HOLD
No .COP I ES : 10
INTERVAL : 2mm
ENTER/HOLD
INTERVAL : 10mm
No .COP I ES <ENT>
ENTER/HOLD