MIMAKI CG-60SL - Perform cutting a dotted line

3-30
Perform cutting a dotted line
When cutting the sheet according to data, the plotter cuts
the design in broken lines without cutting it out.
• For the broken-line cutting, use the cutter (model:
SPB-0001, a set of three cemented carbide blades)
that is optionally available.
• As for dotted line cutting, use the slot side of the pen
line ( P.1-8).
1
Press the key in the local
mode.
2
Press the jog key or to select
[SET UP] .
3
Press the key.
4
Press the jog key or to select
[HALF CUT] .
5
Press the key.
6
Press the jog key or to select
“ON” .
7
Press the key.
8
Press the jog key or to select
the cut pressure for half cutting.
• Setting values : 0 to 300g
Sheet
Cutter
Half-cut length:
Cutting is performed
with a half cut
pressure.
Cut length:
Cutting is performed with
a pressure specified in
the tool conditions.
DATA CLEAR <ENT>
FUNCTION
SET UP <ENT>
ENTER/HOLD
HALF CUT <en t >
HALF CUT :OFF
ENTER/HOLD
HALF CUT :ON
HALFcu t PRESS : 0g
ENTER/HOLD
HALFcu t PRESS : 50g