3-31
Other Useful Functions
3
Useful Function
9
Press the key.
10
Press the jog key or to select
the length of half cutting.
• Setting values : 0.5 to 5.0mm
11
Press the key.
12
Press the jog key or to select
the length of the part of the sheet to be
cut.
• Setting values : 5 to 150mm
13
Press the key.
14
Press the key twice for terminating this function.
Reference value
Cutting conditions and broken-line cutting conditions for the sheet of 65 kg are as shown below.
• The setting values are kept in memory even when the power is turned off.
• Since the broken-line cutting cuts the media together with the base paper, the life of the cutter
blade used for broken-line cutting will be shorter than that of the one used for normal cutting.
• You can set the cut pressure for cutting the sheet using cutting conditions (
P. 2- 9) .
Cutting conditions Broken-line cutting conditions
SPEED 40cm/s Half cut press 0g
PRESSURE 40g Half cut length 0.5mm
OFFSET 0.30mm Cut length 10mm
HALFlength:0.5mm
ENTER/HOLD
HALFlength:2.5mm
CUT LENGTH : 1 0mm
ENTER/HOLD
CUT LENGTH : 1 0 0mm
ENTER/HOLD
END
To Next Page
Loading...
