2-2
Operation flow
1
Installing a tool
2
Turning the power on
3
Setting the tool
conditions
4
Loading a sheet of media
5
Test cutting (plotting)
6
Cutting (plotting)
See "Installing a tool" ( P.2-3)
See "Turning the power on"
( P.2-7)
See "Setting the tool conditions"
( P.2-8)
See "Loading a sheet of media"
( P.2-11)
See "Test cutting (plotting)"
( P.2-18)
See "Cutting (plotting)" ( P.2-19)
7
Turning the power off
See "Turning the power off"
( P.2-21)
To Next Page
Loading...
