2-19
2
Basic Operations
Cutting (plotting)
You can start cutting (plotting) after completion of setting up a tool, loading a sheet and setting the tool
conditions.
Setting the origin
The origin is a reference point for the cutting (plotting) data.
When the origin is to be changed, set the new origin before starting cutting (plotting).
1
Move the head to a point at which the
new origin is to be set.
• ：Moves the head to the right.
：Moves the head to the left.
：Feeds the sheet toward the rear of the plotter.
：Feeds the sheet toward the front of the plotter.
• Every time you press the key, the tool will move up and down alternately.This
helps you to set the origin at a correct position.
2
Press the key to register the
origin.
• The display panel will show the effective cutting
area first and then the tool conditions.
• Check the following settings before executing cutting (plotting).
Setting of the origin ( P.2-19)
Setting of the command origin ( P.3-36)
Switching between commands ( P.3-36)
Priority of commands ( P.3-36)
Setting of the maximum size response value ( P.3-36)
• Change the origin before you make the plotter start cutting for the next data; otherwise, cutting
will be performed over the previous data.
New origin
TOOL
** ORIGIN **
A=**** B=****
CUT1 2 0 050 0 . 3 0
ENTER/HOLD
To Next Page
Loading...
