3-6
Set the distance compensation
When cutting is to be performed along a long length, the cut length may significantly differ from the data
value, depending on the thickness of the sheet. Additionally, the diameter difference between the grit rollers
may cause a significant difference in the sheet feeding distance between the right side and the left side.
This function compensates those differences.
One type of the distance compensation can be set for each set of tool conditions, totally eight types can be
set.
Find compensation value
Compensation value = Measured value of the OFF line - Input reference length
Example） • Measured value of the OFF line = 999.0 mm
• Input reference length = 1000 mm
• 999.0 - 1000 = -1.0 mm / (Compensation value)
Setting value :
• Reference value [ In “mm” ]
In the A direction : 500, 1000, 1500, 2000, 2500 mm
In the B direction : 200, 400, 600 mm
* The set value in the B direction differs according to the model size in use.
• Reference value [ In “inch” ]
In the A direction : 24, 36, 48, 60, 72, 96 inches
In the B direction : 6, 12, 18, 24, 30, 36, 42, 48 inches
• Compensation value
In the A direction : ± 2 % (0.1 mm step)
In the B direction : ± 2 % (0.1 mm step)
Plotting offset : 0 ~ 300 mm
• The distance compensation values are set for each tool.
• If the tool number is changed on the host computer, the compensation values for the newly
selected tool number will be applied to the operation. Take care when specifying the tool
number by commands.
Compensated line
Reference line
Pinch roller
To Next Page
Loading...
