3-32
Perform plotting with perforated lines
You can use a pin to perforate along the outline of data (POUNCING function).
You can mark the perforated sheet with a marker pen, spray or others to use it for positioning of
construction and hand-written signboard.
When POUNCING
Tool : You must use an optional pouncing pin (Model number OPTC0095 : POUNCING
set) that has a needle-shaped cutting edge.
Cutting conditions : You have to set to [PIN].
Sheet : You must use a paper, not polyvinyl chloride sheet.
Pen Line : Remove the pen line rubber, and set the pen line.
Set the Cutting Conditions in advance ( P.2-9)
SPEED : 1 ～ 10cm/s (1 cm/s step)
15, 20, 25, 30, 35, 40, 45, 50cm/s
PRESSURE : 10 ～ 400 (g)
Perforation interval : 1 ～ 100 (mm)
To Next Page
Loading...
