3-2
Functions in the Jog Mode
Press the jog key , , or in the local mode, and then you can enter the jog mode, where
you can perform the following settings.
Setting the origin
1
Press the key to set to the
local mode.
• Confirm in advance that if you press the key to enter the remote mode, the
plotter does not perform cutting (plotting).
2
Press the jog key , , or
to enter the jog mode.
• Press either one of the jog keys, and you can enter the jog mode.
3
Press the jog key , , or
to set the origin.
4
Press the
key to decide the
origin.
• After displaying the set value for while, the plotter
returns to the local mode.
Function names Contents
Reference
page
Setting the origin
Set the point from which the plotter will start cutting (plotting). P.3-2
Two-point axis
alignment
If a ruled sheet is set, align the horizontal and vertical axes with the
appropriate lines on the sheet.
P.3 -3
Cutting area
Set the area in which the plotter performs cutting (plotting). P.3-4
Up and Down
of the Pen
This is to put up and down the tool.
(Press the key in the jog mode).
－
• Before you set the function in the jog mode, be sure to confirm that there is no cutting (plotting)
data.
• When the origin or any other point is set in the jog mode, the center of the tool corresponds to
the setting point.
TOOL
CUT1 2 0 050 0 . 3 0
REMOTE
REMOTE
0.0 0.0
** ORIGIN **
A=**** B=****
ENTER/HOLD
To Next Page
Loading...
