3-4
Cutting area
Set the area in which the plotter performs cutting
(plotting).
The area that has a diagonal line extending from the origin
to a given UL (upper left) point is the available cutting
area. The cutting area setting will be cleared by
performing sheet detection again.
1
Press the key to set to the
local mode.
• Confirm in advance that even if you press the key to enter the remote mode, the
plotter does not perform cutting (plotting).
2
Press the jog key , , or
to enter the jog mode.
• Press either one of the jog keys, and you can enter the jog mode.
3
Press the key.
4
Press the jog key , , or
to set the point UL.
5
Press the key to decide the
point UL.
• After displaying the set value for a while, the plotter returns to the local mode.
• Be sure to set the upper left point in the area located in the normal direction from the origin.
• Be sure to set the origin in the cutting area. If the origin is located outside the cutting area, the
plotter will go into an error state.
Point UL
Origin
Available cutting
area
CUT1 2 0 050 0 . 3 0
REMOTE
REMOTE
0.0 0.0
0.0 600.0
FEED
** CUT AREA **
ENTER/HOLD
To Next Page
Loading...
