3-24
HOLD
If a sheet goes out of alignment while long data is being
cut (picture-drawn), you can temporarily hold the cut for
fixing the misalignment of the sheet.
1
Press the key during the sheet
cutting.
• Be sure to execute the hold function at a break in characters.
If you execute the hold function while the plotter is cutting (plotting) a line segment of a
character, the starting point and end point of cutting (plotting) will not meet.
2
Fix the sheet misalignment.
(1) Fix the sheet misalignment.
(2) Lower the clamp lever.
(3) Press the key.
3
Press the key to restart cutting.
• The key does not work until the sheet is detected.
• In the local mode, hold down the key for approximately 1.5 seconds.
Data after the correction
of sheet displacement
Cut before the sheet
misalignment is fixed.
-- HOLD --
ENTER/HOLD
END
REMOTE
ENTER/HOLD
ENTER/HOLD
To Next Page
Loading...
