2-16
How to Place the Roll Sheet
If you want to use the roll sheet, you must mount the roll-placing table.
1
Raise the clamp lever.
2
Lay down the roll-placing table, fitting
to the width of the roll sheet.
• As the roll-placing table has a magnet, just attach
it to the device and it is fixed.
• Fix the roll-placing table 2 to 3mm away from the
sheet width. Pressing the both ends hard may
cause the roll not to be rotated, resulting in no
sheet feeding.
3
Lay up the roll sheet on the roll-placing
table.
• Be careful about the sheet direction.
4
Pull out the sheet for maintaining.
(1) Pull the sheet tightly and take up the slack.
(2) Make sure that the sheet is loaded without slack,
then raise the clamp lever.
• When the power is on, the absorbing fan is turned
on to absorb the roll sheet.
• If the power is not on, the absorbing fan is not
turned on. Therefore, pressing the sheet with your
left hand so as not to be deformed, raise the
clamp lever.
To slightly hit.
O K N G
To Next Page
Loading...
