Specifications of the main unit
5-3
5
Appendix
Repeatability condition
Plotter conditions
• When using a exclusive roll-placing table.
• The clamp pressure must be set to “HIGH” .
Sheet setting conditions
• Side margin of the sheet: 20 mm or more
• Front side condition of the sheet: No warp or rising
• No separation of the sheet from the base paper (no air bubbles between them), which can be caused
by bending of the sheet
• The sheet must be loaded properly using the sheet feed function.
• The roll sheet must be free from loose rolling . (The right and left end faces must be flat.)
Cutting speed
• 40 cm/s or less (when the cutter supplied with the plotter is used)
Cutting data
• Test pattern for maintenance (continuous 10 strokes in the lengthwise direction)
• During cutting, there must be no separation of the sheet from the base paper (no air bubbles between
them), which can be caused by excessive bending of the sheet.
• The specified repeatability may not be guaranteed depending on the material of the sheet to
be cut or ink jet media,
To Next Page
Loading...
