2-21
2
Basic Operations
Turning the power off
When plotting is completed, press the “ O ” side of the power switch to turn the power off.
1
Confirm that the plotter is not receiving
any data.
• Make sure that the display is indicating REMOTE
or LOCAL.
2
Press the “ O ” side of the power
switch.
• The POWER lamp on the operation panel turns
off.
• Once the power is turned off, wait at least five seconds before turning the power on again.
CUT1 * REMOTE *
CUT1 2 0 050 0 . 3 0
To Next Page
Loading...
