2-14
Loading a leaf sheet (cut sheet)
1
Press the key to switch to
NOT READY mode.
• You need not to do so if it’s already in the NOT
READY mode.
Start operation from the Step 2.
2
Load the leaf sheet on the platen.
(1) Push a clamp lever up to raise a pinch roller.
(2) Set the right end of the sheet considering the platen
vertical rib as the measure.
Or, align the near end of the sheet in parallel with the
platen.
3
Move the pinch rollers so that they suit
the sheet width.
• Locate each of the pinch rollers 5 mm or more
inside the sheet edge; otherwise, the sheet can
slip off the pinch rollers while it is being fed.
4
Push a clamp lever down to lower the
pinch roller.
ROL L < R > LEAF
SHEET SET
To Next Page
Loading...
