MIMAKI CG-60SL - Page 37

2-13
Loading a sheet of media
2
Basic Operations
Method of detecting a sheet
When a sheet of media is set, the following two displays will appear alternately on the LCD panel.
Align to the direction of the set sheet, and press the jog keys , , or .
The plotter uses the five different methods to detect a sheet of media as shown below.
Key
This key sets the
roll sheet in the
back side.
This key sets the
discard in the back
side.
This key detects
only the sheet width.
Detecting
method
The sheet width is
detected
Front side of the plotter
After the sheet width is
detected, The back end of
the sheet is detected.
Front side of the plotter
The sheet width is
detected
Front side of the plotter
Example of
display after the
sheet detection
Key
This key sets the roll
sheet in the front
side.
This key sets the
discard in the front
side.
Detecting
method
After the sheet width is
detected, The back end of
the sheet is detected.
Front side of the plotter
After the sheet width is
detected, The back end of
the sheet is detected.
Front side of the plotter
Example of
display after the
sheet detection
• When the detected length is 3 m or more, the display “ **** ” will appear on the LCD.
• When a long sheet of media is used or a sheet which has already been drawn out is used from
its middle area, the sheet detection will require an extended period of time. In such a case, the
detection time can be reduced by detecting only the sheet width.
R set
A sheet is set from
the rear side.
F set
A sheet is set from
the front side.
ROL L < R > LEAF
ROL L F LEAF
< >
B
Origin
A
B
Origin
Origin
B
A=**** B=123 A=567 B=123 A=**** B=123
A
B
Origin
A
B
Origin
A=**** B=123 A=567 B=123