MIMAKI CG-60SL - Switch the cutting (plotting) direction

3-14
Switch the cutting (plotting) direction
This function sets the location of origin and direction of the axes of coordinates according to the application
software to be used.（ROTATION 機能）
The Setting of ROTATION.
1
Press the key in the local
mode.
2
Press the jog key or to select
[SET UP] .
3
Press the key.
4
Press the jog key or to select
[ROTATION] .
5
Press the key.
6
Press the jog key or to select
Setting.
ON : Performs the rotation of the axes of coordinates and the movement of the origin at the
same time.
OFF: Does not perform the rotation.
• The setting values are kept in memory even when the power is turned off.
• Confirm that any data to be cut is not saved in the receiving buffer. If you change the set
values, the contents of the receiving buffer are cleared completely.
Rotating function : OFF
Origin
Rotating function : ON
Origin
• After the sheet detection, the
carriage will stop at the origin.
DATA CLEAR <ENT>
FUNCTION
SET UP <ENT>
ENTER/HOLD
ROTAT I ON < e n t >
ROTAT I ON : OFF
ENTER/HOLD
ROTAT I ON : ON