This chapter describes the setting procedures of each functions,
and how to operate the plotter usefully.
Functions in the Jog Mode.............. 3-2
Setting the origin .................................3-2
Two-point axis alignment .....................3-3
Cutting area .........................................3-4
Digitization operation ...........................3-5
Set the distance compensation ...... 3-6
Perform Multiple Cuttings ............. 3-10
Expand the cutting (plotting) area 3-12
Set the EXPANDS function to ON. ....3-12
Switch the cutting (plotting)
direction.......................................... 3-14
The Setting of ROTATION. ...............3-14
Perform DIVISION CUT. ................. 3-16
Set for DIVISION CUT. ......................3-16
Cut Data via DIVISION CUT. ............3-18
Change the cutting (plotting)
order................................................ 3-19
Set SORTING . ..................................3-20
Sorting sequence ..............................3-22
Other Useful Functions ................. 3-23
Feed the paper ..................................3-23
HOLD ................................................3-24
DATA CLEAR
- Discontinue Plotting - ......................3-25
Perform SAMPLE CUT to Find out the
Cause of Cutting Error. ......................3-26
Output the Setting List .......................3-27
Output the received data by the ASCII
code [ASCII DUMP] ...........................3-28
Set each device number for USB
connection .........................................3-29
Perform cutting a dotted line .............3-30
Perform plotting with perforated lines 3-32
Miscellaneous Settings................. 3-34
Switch the display language ..............3-34
Other Convenient Settings ................3-35
Reset the setting values to the
initial state. ........................................3-41
CHAPTER 3
Useful Function
To Next Page
Loading...
Need help?
General
