3-7
Set the distance compensation
3
Useful Function
Setting procedure
1
Press the key in the local mode.
• Tool conditions are displayed with the cursor
blinking at the [SPEED] value.
2
Press the jog key .
• The cursor blinks at the tool number.
• Press the jog key or to change the tool number.
3
Press the jog key .
• Press the jug key to return to select the tool
number.
4
Press the key .
• The display shows each of the current
compensation values for about one second first. Then the display shows the reference
length (mm) that was subjected to the previous compensation.
• If no distance compensation has been performed, the minimum reference length will be
displayed.
• The display will be as shown at right if the selected unit of
length [MM/INCH] is different from that selected at the
previous compensation.。
5
Change the reference lengths in the A direction (back and forth
direction) with the jog key or .
• The reference length in the A direction turns out to be the reference length for both of AR
(back and forth direction in the right side) and AL (back and forth direction in the left side).
• If you change the reference lengths in the A direction, the distance compensation values
(AR, AL) will be cleared.
6
Press the key to determine
the reference length in the A direction.
• You can determine it also with the jog key .
• Move to set the reference length in the B direction.
CUT1 2 00500.30
TOOL
C U T1 20 050 0. 30
DIST.COMP. <ENT>
A=500 B=200
ENTER/HOLD
A=---- B=----
A=1000 B=200
ENTER/HOLD
To Next Page
Loading...
