3-17
Perform DIVISION CUT.
3
Useful Function
6
Press the to select “ON.”
7
Press the key.
8
Press the jog key or to select
[FRAME CUT] .
• Select “ON” for the frame cut.
9
Press the key.
10
Press the jog key or to select
[MARK CUT] .
• Select “ON” for the mark cut.
11
Press the key to perform setting,
and press the key twice to terminate this function.
Reset the setting for DIVISION CUT.
• The setting values are kept in memory even when the power is turned off.
• Since the overlap margin is 1 cm, the available cutting area must be wider than 1 cm.
• During execution of division cutting, the plotter ignores any other data sent from the host
computer.
• In any of the following cases, the plotter cannot perform division cutting.
a ) The data size is larger than the receiver buffer capacity.
b ) An origin change command is contained in the cutting data.
c ) A two-point compensation value has been set.
d ) The width of available cutting area is 1 cm or less.
e ) The plotter cuts the test data stored in it.
Follow the Steps 1
to 5 of "Set for
DIVISION CUT."
Press the jog key
to select
“OFF.”
Press the
key.
Press the
key twice.
D I V I S I ONc u t : ON
FRAME CUT :OFF
ENTER/HOLD
FRAME CUT :ON
MARK CUT : OFF
ENTER/HOLD
MARK CUT : ON
ENTER/HOLD
END
ENTER/HOLD
END
To Next Page
Loading...
