Troubles for which error messages are given on the LCD
4-7
4
In Case of Trouble
Message Cause Remedy
MEDIA SKEW
<ENT>
The deviation of the sheet exceeded
the setting value of the SKEW CHECK
(
P.3 -22 )
Press the key after
resetting the sheet.
F-ROM WRINTING
The plotter is now storing the tool
parameters and setting parameters.
The data is saved in flash memory so
that the saved data will not be erased
even when the power is turned off.
Do not turn the power off while this
message is displayed.
*TRANSMIT START*
It is in version-upgrade mode, since
key has been pressed when
turning the power on.
Turn the power off once and turn it on
again.
If the same message appears, contact
your distributor or a sales office of
MIMAKI.
SHEET END
REM/END
End of the sheet is detected while
detecting a mark or cutting roll sheet.
Cutting cannot be continued, since roll
sheet has ended.
Press the key and replace it
with new sheet.
Sheet is lifted.
Fix the lifting of the sheet and press the
key to resume cutting.
The back of the plotter is exposed to
intense light.
Turn the plotter around not to be
exposed to the light, and press the
key to resume cutting.
ENTER/HOLD
REMOTE
END
REMOTE
REMOTE
To Next Page
Loading...
