4-40
Copying the Setting Contents
The setting contents can be copied to other tool conditions.
1
Press the key in LOCAL to select the
cutting mode.
2
Press the key.
3
Press the key.
4
Press to select one from the tool conditions (CUT1 to CUT3, PEN, and
HALF) and press the key.
5
Press to select [SETUP COPY].
6
Press the key.
7
Press to select the tool condition to copy (CUT1
to CUT3, PEN, HALF or ALL).
• If “ALL” is selected, the set contents of all tool conditions are same.
8
Press the key.
9
Press the key.
10
Press the key several times to return to LOCAL.
• You cannot copy the setting performing with the key (speed, cutting pressure, offset
value).
To Next Page
Loading...
Need help?
General