5-5
Common Settings
5
Extended Functions – Common Settings –
Setting CONFIRM. FEED
Set whether or not to feed the medium for checking when test printing is finished.
1
Press the key in LOCAL.
2
Press to select [COMMON SETUP].
3
Press the key.
4
Press to select [CONFIRM FEED].
5
Press the key.
6
Press to select the length to be fed
(10 to 500mm).
• When having selected [OFF], proceed to Step 9.
7
Press the key to set [BACK FEED].
8
Press to select ON/OFF.
• ON : To slightly take-up the medium fed by the confirmation feeding function.
• OFF: Not to take-up the medium.
9
Press the key.
10
Press the key several times to end the setting.
Set Value Overview
OFF
The medium will not be fed after test printing/cutting.
10 to 500mm
Sets the length to be fed after test printing/cutting. If the length is set, the setting can be set to take up the
fed medium a little. (from Step 7)
To Next Page
Loading...
