Perform Multiple Cuttings
4-47
4
Extended Functions – Cutting –
• When copying data to produce a multiple number of pieces of data, make sure to set an origin again.
When, immediately after data is copied to produce a multiple number of pieces, a piece of data is cut
according to a specified number without setting an origin, data is cut (plotted with a pen) with
themselves being overlapped.
• While data is being cut into pieces according to a specified number, data from the host computer cannot
be received.
• There must be an interval of 10 seconds or more between the preceding data and the succeeding one
transmitted from the host computer. When the succeeding data is transmitted within 10 seconds, both
two data are cut into pieces according to a specified number.
• Data to be divided and cut is not divided, but cut into pieces according to a specified number. When an
error is displayed, see "Error Messages" ( P.7-10).
To Next Page
Loading...
Need help?
General