Maintaining Capping station
4-13
4
Routine Maintenance
5
Press the key.
6
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill up the cap with cleaning solution on the verge
of overflow from the cap.
7
Close the front cover and press
the key.
8
Set the duration for leaving the cleaning
solution by pressing the keys.
• Set value : 1 to 99 minutes (Unit: minute)
9
Press the key.
• Perform the nozzle cleaning.
• On completion of the nozzle cleaning, the head moves to
above the platen.
10
Open the front cover.
11
Press the key to fill the cap with the cleaning solution.
• The cleaning solution is applied to the cap by drops when the is pressed.
• When the is pressed again, drops stop.
• During the idle absorbing is interrupted, repeat the drops several times to fill the cap with
the cleaning solution just before the solution overflows from the cap.
12
Close the front cover and press the
key.
• It returns to the local mode after the initial operation.
Fi l l the l iquid
COMP L ETED ( NEXT ) : e n t
ST . MA I NTENANCE
LEAV ING T IME :
1
mi n
ST . MA I NTENANCE
LEAV ING T IME :
2
mi n
*Be i ng In i t i a l i zed*
PLEASE WA I T
*Be i ng In i t i a l i zed*
PLEASE WA I T
<LOCAL . 1>
To Next Page
Loading...
