4-12
When not using for a long term (CUSTODY WASH)
When the operation of the machine is to be suspended for a week or more, use the [CUSTODY WASH]
function to clean the nozzles in the heads and the ink discharge passage.
After the cleaning, store the machine properly.
1
Press the key in the local mode.
2
Select [CUSTODY WASH] by pressing the
keys.
3
Press the key.
• The carriage moves onto the platen.
4
Clean the wiper and the bracket.
(1) Open the front cover then pull out it by holding projections at both ends of the wiper.
(2) Clean it with a clean stick dipped in the cleaning solution. (SPC-0137)
(3) Insert it in the original position by holding the projections at both ends of the wiper.
Check the follow-
ings in advance.
Is [NEAR END] or [NEAR END] displayed ?
• The cleaning solution or ink is absorbed in washing.
At this time, washing is unable to operate if the ink end or near-end is
detected.
• Replace it with a cartridge undetected for the ink end or the like.
• When the following messages are indicated, check the waste ink tank, and then operate it,
referring to P.4-34 “If Waste ink tank confirming message is displayed” according to the situa-
tion.
Con f i rm a was t e tank
Con t i nue< >Exchange
Con f i rm a was t e tank
Exchange :
e
nt
ST . MA I NTENANCE
CARR I AGE OUT < e n t >
ST . MA I NTENANCE
CUSTODY WASH < e n t >
WI PER CLEAN I NG
COMP L ETED ( NEXT ) : e n t
To Next Page
Loading...
